Just installed build Tomato Firmware 1.28.0000 -140 K26ARM USB AIO-64K on a Netgear R7000. Seems to load ok, but even after setting up the vlan ports, I can't get anything under Basic->Network to save. The "save" button doesn't seem to do anything on this particular page. The save button works on a lot of the other pages I've tried, but not on the page where I can set up the WAN, so I can't really do anything. I'm upgrading from k24, and I'm only using one WAN, so there are a lot of...
Shibby on Netgear R7000 save button disabled under Basic->Network
Shibby on Netgear R7000 save button disabled under Basic->Network