I just installed a new RT-AC68P/U B1 to replace my older RT-N66U. I cleared the NVRAM after flashing Shibby Tomato 1.28.0000 -140 K26ARM USB AIO-64K and then setup the new router using the same settings I had used on the RT-N66U that was running Shibby Tomato 1.28.0000 MIPSR2-140 K26 USB AIO-64K.
All works fine except one thing, when I open the Device List on the new RT-AC68 I see all the attached devices IPv4 address but unlike the RT-N66U I don’t see the IPv6 addresses. My old RT-N66U...
Shibby Tomato Device List Not Showing IPv6 Addresses
All works fine except one thing, when I open the Device List on the new RT-AC68 I see all the attached devices IPv4 address but unlike the RT-N66U I don’t see the IPv6 addresses. My old RT-N66U...
Shibby Tomato Device List Not Showing IPv6 Addresses