Concerning Netgear R7000.
I had tomato shibby 2.38 before.
Installed per usual instructions and cleared nvram via gui.
But I always had trouble rebooting the computer.
It would just continue to reboot unless I removed WAN cable until it had finished rebooted.
Not a biggie but I always had to be there physically when rebooting.
I installed shibbys new 2.40 firmware and cleared NVram via gui as usual.
Still had the same problem with reboots.
Then I did something stupid and set my DHCP to...
Clearing NVRAM via GUI
I had tomato shibby 2.38 before.
Installed per usual instructions and cleared nvram via gui.
But I always had trouble rebooting the computer.
It would just continue to reboot unless I removed WAN cable until it had finished rebooted.
Not a biggie but I always had to be there physically when rebooting.
I installed shibbys new 2.40 firmware and cleared NVram via gui as usual.
Still had the same problem with reboots.
Then I did something stupid and set my DHCP to...
Clearing NVRAM via GUI